Home > News > Content

Considerations For Ultra-thin Turbine Blades

Jul 11, 2017

               Ultra-thin Turbine Blade ultra-thin turbine blades belong to the diamond saw blades, the overall adoption of ultra-thin design, cutting down on the waste of materials, the knife to adopt streamline turbine design, chip more thorough, cutting faster and more flat, the sharp edge of the knife, a brisk and high efficiency. Special ultra-thin body, deep cold quenching treatment, mild high, no deformation.Ultra-thin turbine blades

               Before use should confirm whether the saw blade has the breakage, if has the breakage, forbids to use. When assembling, the motor shaft and saw blade center hole Germany cooperate, the error must be less than 0.1mm. Note that the direction of the arrow indicated on the saw blade is consistent with the direction of the tool being rotated. When cutting, please do not apply side pressure and curve cutting, into the knife to smooth, avoid the blade impact contact the workpiece, in order to avoid danger. Dry-cut, do not carry out long time continuous cutting, so as not to affect the life of the saw blade and cutting effect, wet slice cutting, should add water cooling, beware of leakage. Experts suggest, after the saw piece is installed, should be idling a few minutes first, confirm no swing or beat, after the grinding wheel or refractory brick on the first try to cut a few knives, and then normal work effect is best. If the sharpness of the saw blade is not enough, please use silicon carbide to sharpen the blade. Cutting Confidential has a safety shield, operators must wear safety clothing, glasses, masks and other protective supplies.Ultra-thin turbine blades

               Measurement mode: Using delay and immersion probes, thickness measurement can use Mode 2 (interface wave to first echo) or mode 3 (Echo to echo after interface Wave). Mode 3 provides better thin material resolution than mode 2, which is possible only if the measured points on the turbine blades produce multiple echoes. If only a single available echo (due to curvature and attenuation), the measurement must use mode 2. The 25DL Plus model can be operated in mode 2 or mode 3. For a given turbine blade application, the optimum setting is established, with the help of the reference standard, to perform the measured thickness range and geometry.Ultra-thin turbine blades