Home > News > Content

Installation Grinding Wheel

Aug 28, 2017

                 Location problem the location of the grinding wheel machine is the first question to be considered during the installation process, and we can do other work only if we choose a reasonable and suitable position. Grinding Wheel machine is not installed in the vicinity of the equipment and operators or often people past the place, the general large workshop should be set up dedicated grinding wheel room. If you do not set up the special grinding wheel room due to the limitation of the terrain of the plant, it should be installed on the front of the grinder not less than 1.8m height of the protective bezel, and the bezel requirements are firmly and effectively.Grinding wheel

                 The imbalance of the grinding wheel is mainly caused by the inaccurate manufacture and installation of the grinding wheel, which makes the center of gravity of the grinding wheel not coincide with the rotary shaft. The damage caused by imbalance is mainly manifested in two aspects, on the one hand, when the grinding wheel rotates at high speed, it causes the vibration and easily produces the angular vibration mark on the workpiece surface. On the other hand, the unbalance accelerates the vibration of the spindle and the wear of the bearing, which can cause the grinding wheel to rupture Therefore, the requirements of a large, greater than or equal to 200mm sand Office installed on the card plate should be a static balance, the wheel after the plastic dressing or in the work to find imbalance, should be repeated static balance.Grinding wheel

                 Matching problem is mainly refers to the installation of Chuck and wheel. According to the standard requirements, the grinding wheel chuck diameter must not be less than 1/3 of the diameter of the installed sand plate, and the corresponding provisions of the wheel wear to diameter than the diameter of the card plate 10mm should replace the new grinding wheel. In this way there is a matching problem between chuck and grinding wheel, otherwise, the "Big horse cart" causes the waste of equipment and materials, "small horse cart" does not meet the safety requirements, easy to cause personal accident. Therefore, the reasonable matching between chuck and wheel can save equipment, cut about material, and meet safety operation requirement on the other hand. In addition, between the wheel and the Chuck should also be installed in diameter larger than the diameter of the chuck 2mm, thickness of 1mm~2mm cushion.Grinding wheel