Home > News > Content

Ultra-thin Turbine Use Range

May 22, 2017

Ultra-thin turbine blades are diamond saw blades, the overall use of ultra-thin design, cutting to reduce the waste of the material, the head to take streamer turbine design, chip removal more thoroughly, faster and more smooth cutting, Light and efficient. Special ultra-thin body, cryogenic quenching treatment, mild high, no deformation.

Ultra-thin turbine sheet precautions

· Before use, check whether the saw blade is damaged, if damaged, is strictly prohibited. When assembling, the motor shaft and the blade center hole with the error must be less than 0.1mm.

• Keep the arrows on the saw blade in the same direction as the tool. Cutting, please do not apply side pressure and curve cutting, feed to be smooth, to avoid the impact of contact with the workpiece blade, so as to avoid danger.

· Dry cut, do not carry out a long continuous cutting, so as not to affect the life of the saw blade and cutting effect; wet film cutting, water should be cooled, beware of leakage.

Experts recommend that the saw blade installed, you should first idle for a few minutes to confirm no swing or beating, in the wheel or refractory brick on the first test knife, and then the best working results. If the blade is not sharp enough, please use silicon carbide grinding stone blade.

· Cutting machine to have a safety shield, the operator must wear safety clothing, glasses, masks and other protective equipment.

Before use should confirm whether the saw blade is damaged, if damaged, is strictly prohibited. When assembling, the motor shaft and the blade center hole with the error must be less than 0.1mm.

• Keep the arrows on the saw blade in the same direction as the tool. Cutting, please do not apply side pressure and curve cutting, feed to be smooth, to avoid the impact of contact with the workpiece blade, so as to avoid danger.

· Dry cut, do not carry out a long continuous cutting, so as not to affect the life of the saw blade and cutting effect; wet film cutting, water should be cooled, beware of leakage.

Experts recommend that the saw blade installed, you should first idle for a few minutes to confirm no swing or beating, in the wheel or refractory brick on the first test knife, and then the best working results. If the blade is not sharp enough, please use silicon carbide grinding stone blade.